HYPEL™
LLDPE 3170 UV 8 NATURAL ** LINEAR LOW DENSITY POLYETHYLENE,
7.0 MFI
TYPICAL
PROPERTY VALUES†
PROPERTY
METHOD
UNIT
VALUE
PHYSICAL
Specific
Gravity
ASTM
D792
0.935
Metal
flow (190°C / 2.16 kg)
ASTM
D1238
g/10
min
7
MECHANICAL
@ 73°F
Tensile
Strength at Yield
ASTM
D638
psi
2720
MPa
18.8
Flexural
Modulus - 1% Secant
ASTM
D790
psi
100,000
MPa
655
ARM
Impact 1/8" (Notched) @-40°C
ASTM
D562B
ft-lb/in
79
Hardness
(Shore D)
ASTM
D785
-
-
THERMAL
264
psi - ASTM, 1.80 MPa-ISO
ASTM
D648
°C
35
°F
95
66
psi - ASTM, 0.45 MPa-ISO
ASTM
D648
°C
52
°F
125
OTHER
ESCR
(100% IGEPAL)
>1000
**When
used unmodified for food contact applications, this copolymer
will comply with the U.S. Food and Drug
Administration Food Additive Regulation 21 CFR 177.1520(c)3.1a.
This section does not include use in packing or
holding food during cooking. This product is limited to use
in contact with food only under the conditions of use C
through H described in table 2 of Sec. 176.170(c), and when
contacting fatty foods of Types III, IVA, V, VII-A,
and IX described in table 1 of Sec. 176.170(c), the finished
articles are to have a volume of at least 18.9 liters (5
gallons). The uses cited are subject to good manufacturing practices
and any limitations, which are part of the
regulations. The regulations should be consulted for complete
details.
†The data listed here fall within the normal range of product
properties, but they should not be used to establish
specification limits or used alone as a basis for design. This
information is not intended as a warranty of any kind.
Buyers must make their own representative test and assume all
risks of use, whether used alone or in combination
with other products. Entec Polymers, LLC assumes no obligation
or liability of any advice furnished by it or results
obtained with respect to these products. All warranties expressed
or implied including warranties of merchantability
for a particular purpose or use are excluded and disclaimed.
Entec Polymers, LLC assumes no liability for use of
products in infringement of any patent. The foregoing limitation
of remedy and exclusion of liability is reflected in
and is part of the consideration for the price, at which the
products are sold by Entec Polymers, LLC. All data
displayed herein has been obtained via testing of injected molded
specimens of natural color. Pigmentation may affect
certain properties to various degrees.
Plastic Bench
Seating, Plastic Benches, Plastic Chairs, Chairs, Plastic
Two-Person Bench, Metal Bench, Metal Armor,
Bench, Benches, Park Benches, Polysteel, Site Amenities, Site
Furnishings, and Steel Mesh Benches from your source for material
handling equipment.
