Die Lifting Tong, Die Lifting Tongs, Lifting Tong, Lifting Tongs

Back to Product Page

LIFTING TONGS
Standard Support Type

MODEL 70 - DIE LIFTING TONGS

					PRODUCT FEATURES:

					Broad Capacity Range

					Low Headroom models

					Registration Tag with Serial Number

					Painted Safety Red

					Designed and manufactured to ASME B30.20

					See below for general information on Lifting Tongs


			Order Online, by Phone, or by E-Mail
			~ Add items to your online shopping cart ~ Click a Model No. of the item you wish to purchase.

PRICING AND SPECIFICATIONS



GENERAL INFORMATION:

	Lifting Tongs are designed and manufactured to customer load specifications. Optional is an automatic latching device.

	All Lifting Tongs are designed and manufactured to conform with ASME B30.20 standards.


Lifting tongs are available in three configurations.

	1. GRIPPING - Grab arms conform to load surface with outside diameter supported below center of load for additional holding advantage.

		Designed to lift such products as rolls, tubes, and other cylindrical materials.


				2. PRESSURE - Grab arms grip vertical sides of straight sided materials. Custom grip pads are required to have sufficient coefficient of friction between material lifted and grip pads. Grip pads may be rubber, steel, belting, points and other.

					Designed to lift such products as bales, boxes, ingots, and other straight sided materials.

					Standard tongs for bales and slabs see Model 77 - Bale Lifting Tongs and Model 71 - Slab Tongs section.


				3. SUPPORTING - Grab arms have feet to support underneath load. Designed to handle constant sizes of material to maintain a horizontal plane on the lifting feel. Dunage under material required to insert/remove feet of tong.

					Designed to lift constant sized boxes, containers, crates, and other constant sized square shaped material.

					Standard Tongs for dies see above (Model 70)


Application Ideas for Supporting Tongs...
	to lift constant sized boxes, containers and crates

This SUPPORT TONG is used for constant sized containers. It has an arm design that allows significant height on the lifted item and includes an auto-latch mechanism for single person control. This auto-latch allows the operator to position, engage, lift, move, place and disengage the lifted item without assistance from another individual or without moving from the crane/hoist control station.


This SUPPORT TONG is also used for constant sized containers. It has the auto-latch and added length to handle longer loads. The top guide stops simplify the auto-engagement and single operator use.

LIFTING TONGS